Classification Of Bathtubs
Apr 10, 2022
The bathtub is the main equipment of the bathroom. There are many types of forms and sizes. They can be divided into three types: deep square, shallow long and eclectic. When people take a bath, they need water to cover their shoulders, so that the whole body can be warmed. Therefore, the bathtub should have a certain water capacity. If the bathtub is too small, it will be uncomfortable for people to curl up in it, and if it is too large, it will feel unstable. The deep square bathtub occupies a small area, which is conducive to saving space; the shallow long bathtub can be laid flat, and the body can be fully relaxed; the compromised shape takes the length of the two, which can not only allow people to straighten their legs into a semi-recumbent position , and save some space.
There are three types of bathtub layouts in the bathroom: shelving, embedded and semi-sunk. The shelving type is to place the bathtub against the corner of the wall. This method is convenient for construction and easy to maintain. It is suitable for use when the floor and ground have been decorated. Embedded is to embed the bathtub into the countertop, which is good for placing toiletries, but it takes up a lot of space. The semi-submerged type is to bury 1/3 of the bathtub under the ground. The bathtub is about 400mm above the bathroom floor. Compared with the shelving type, it is easier and more convenient to get in and out of the bathtub. It is suitable for the elderly and infirm.
According to whether it can be folded, the bathtub can be divided into a folding bathtub and a non-folding bathtub. The material of the tank body of the folding bathtub: the double-layer waterproof cloth is used, and the sponge is attached as the cylinder body. The thickness of the sponge is ≥5mm, and the color of the waterproof cloth is bright. The surface has no wrinkles, no cracks, and the zipper can be pulled back and forth freely. Folding bracket: The load-bearing support bracket is composed of stainless steel square tubes of 25mm×25mm and 22mm×22mm, and the upper mouth is composed of stainless cylinder round tubes of 20-22mm. The surface is smooth and the folding part can be folded freely. Backboard: Made of stainless steel round or square tube welded, it can be turned over freely and fixed firmly. Waterproof pull-off force: ≥450N/50mm, elongation at break: ≥15%.
